What does it use to transform gold and silver jewelry to melt gold and silver?

4 Comments / Jewelry Wholesale / By

There is something like a pen in the jewelry, which can spray fire to gold. What is that?

4 thoughts on “What does it use to transform gold and silver jewelry to melt gold and silver?”

  1. Sonya

    The transformation of gold and silver jewelry, the gold and silver melting is a portable gas welding gun, also known as a universal lighter. Using high -voltage jet technology (a supercharger at the top of the fuselage), the gas is compressed in the supercharger, and it is violently sprayed out under the action of huge pressure, so that the flame temperature is as high as 1300 to 3000 degrees. Can be used to process welding aluminum, tin, gold, silver, plastic, etc.
    If for welding cutting and repairing plastic products, it can also be used as a strong windproof lighter, and the wind can be adjusted.
    Pucting information:
    The ones of the use of air welding torch
    1, radiation -sucking welding torch, you must check whether the shooting performance is normal before ignition, and the connected parts connected to the welding gun and the needle valve of the handwheel to adjust the hand wheel Wait for the illegal air.
    2, after passing the above inspection, you can ignite. When igniting, turn on the acetylene wheel, ignite acetylene and immediately turn on the oxygen regulating handwheel to adjust the flame.
    3, when the flame stops using it, it should be closed first to regulate the hand wheel to prevent the recovery and black smoke.
    4, all gas pathways of the welded torch are not allowed to be contaminated with fat to prevent oxygen from encountering oil and burn and explode.
    5. Select the appropriate welding torch and welding mouth according to the thickness of the weld. Tighten the welding mouth with a panel and twist it until the air is not leaking.
    6. During the use process, if the gas pathway or valve is found, the phenomenon of leakage is found, and the work should be stopped immediately.
    7. The welding guns that are being burned are not placed on the welded or ground.
    8. After the work is suspended or ended, the oxygen and acetylene bottle should be closed, and the pointer of the pressure gauge should be adjusted to zero. At the same time, the welded and rubber pipe disk should be good, hanging on the shelf of the wall or removing the rubber tube to store the welding tube in the toolbox.
    9. When the mouth is blocked, the mouth of the mouth is strictly prohibited from rubbing with the tablet, and the application of the needle is cleaned to eliminate the blockage.
    Reference information Source: Baidu Encyclopedia-Qi Welding Toring

  2. Guadalupe

    Hello, I just opened the gold and silver processing store. The tool you said is called a musket in the line. To be accurate, gasoline spray a gun. The above two states are not peers at first glance. Qi cutting pure industrial oxygen is easy to use. Of course, you can also melt gold and silver, but you need to add liquefied gas, which is our general home gas. Guide the output pressure. If you use the so -called pen to blow candlelight, I think if you can keep blowing for 20 minutes and you must shake it well, you can do it. I believe you can do it!

  3. Kristen

    That is called welding torch `with gasoline` useful and useful electricity. There are not many types of types of oxygen welding that will splash Jinfei because the wind is too strong `and the golden melting point of gold is very low. The easiest thing to teach you how to make you finance. First of all, prepare a ball -beaded pen heart. Remove the pen water and grind the comparison to ventilation. It is best to be a piece of material on the necklace. Then click a candle. The pen is blowing at the candle. Let him shoot a sharp fire. Brick or wood pads can be `` no one minute can melt away ``

Leave a Comment